Installation And Adjustment (1). Motor Installation - Siruba C007K Manual

2. Installation and Adjustment:
(1). Motor installation:
A). When motor and machine installed together, refer to the machine head's instruction.
B). When motor installed under the working table, drill holes in the table as the following diagram for
the installation.
For USA Base
hole
Drill 9 mm
216
table
66
Oil tank
1). Pulleys of motor and machine must properly align.
2). Cable pass through under the working table must be secured to avoid the V-belt to be rubbed.
3). Use the motor base arm to adjust belt's tensions.
C).M5 interlock mode motor installation:
1. Takes off the heat exhaust fan and pulley of sewing machine.
2. Puts coupling
3. Fix the set screw
of shaft or carve
4. Fix the fan cover
5. Fix M 5 motor on fan cover
motor, joint direction must pay more attention on it.
6. Fix fan cover of motor
○
F
Drill 40 mm
57
105
Oil
○
A into shaft of sewing machine，heat exhaust fan closes to shaft.
○
B of coupling. Warning ：Clamp sets crew of coupling must fix in flat surface
○
C .
○
D of motor.
○
E .Warning：There is against dull design for coupling of sewing and
○
F .
○
B
○
E
For Cable
hole
70
70
tank
○
D
○
C
○
A
There is against dull design for coupling of
sewing and motor, joint direction must pay
more attention on it.
3
For Din Base
hole
Drill 9 mm
190
table 57
70
Oil tank
Clamp sets crew of coupling
must fix in flat surface of shaft or
○
carve C .
105