Siruba ASP-EBJ100 Instruction Book page 31

G.Band Remaining Sensor
When the band material is white
or thin enough to allow the light
going through, there might be a
mis-reading. Then you need to
adjust the sensor accordingly.
1. Turn on the power.
2. Insert the test band into the
sensor.
3. Relocate the sensor ④ (tilting) to
lower the sensitivity.
4. Check the indicator of sensor
(on the right of the sensor). The
indicator goes ON when there is
no band.
H.Cutter
1. Uninstall the cover ① and ② .
2. Loosen screw ④ to remove the
cover ③ .
3. Remove the screws ⑥ to change
the Moving Cutter ⑤ .
④
①
②
⑥
⑤
④
③
P21