Table of Contents
Advertisement
B.Correct the variance of band
joining.
1. When the right end of the circled
band strays inward. (as shown
below in the left):
Loosen screw ① . Move the
Band Clipper ② outward
(direction 3).
2. When the right end of the circled
band strays outward :
Loosen screw ① . Move the
Band Clipper ② inward.
3. As shown below in the right,
adjust the clipper position
according to the deformation of
the band joint ④ , ⑤ . Check
from the side of the band.
C.Intensity of air blow
The intensity of air
blower ⑥ ~ ⑨ varies according
to the work request. Adjust
the throttle valve individually if
needed.
P18
①
②
④
⑤
③
⑥
⑦
⑧
⑨
Advertisement
Table of Contents
