Table of Contents
Advertisement
E. Presser Foot and Fabric Plate
1. Uninstall the needle. Enter the
sewing machine solely running
mode. (Testing Mode B)
2. Set sewing pattern
3. Press RESET ⑥ to lower the
presser foot.
4. Press +/FORWARD ⑦ . Move
the Presser Foot ⑧ or Fabric
Plate ⑨ to the limit of either side.
Spare the distance between the
Needle Center and Fabric Plate
⑨ to be 1.5mm.
5. The inner of Presser Foot ⑧
should be 1.5mm farther than the
inner of Fabric Plate ⑨ . (3mm
from the needle center)
6. Adjust the Presser Foot and
Fabric Plate individually.
F. Joint Seam Sensor
1. Loosen screws ③
2. When ① passes the joint seam
sensor, adjust the switch ②
horizontally until the sensor
activated.
P20
⑦
⑧
1.5mm
3mm
⑨
①
⑥
⑧
1.5mm
⑨
②
③
3mm
Advertisement
Table of Contents
