FEEDING THE BAND
※ Caution: a band with wrinkle or rumple may cause quality issue or even damage to the machine.
Part A.
Open the induce plate ① and supporting roller ② . Insert the band through. (*1)
Part B.
1. Insert the band onto the table ④ and through the rail ⑥ , adjust the knobs ③ to set the band width.
2. Release the supporting roller ⑤ to allow the band going into the rollers ⑦ . (*2) Check if the band aligns with the
wall ⑧ closely. Then turn on the power. (p.10)
①
②
Note: *1: To join bands for feeding, please refer to illustration as below.
*2: It is good enough as long as the front end of the band is clamped. No need to force in.
P6
【Part A】
【Part B】
③
④
⑧
Join the band with tape or glue. Do not
apply staple or any other hard material.
⑥
⑤
⑦