Siruba ASP-EBJ100 Instruction Book page 32

4. Remove the screws ⑧ , ⑨ to
change the Fixed Cutter ⑦ .
5. The blade of Fixed Cutter ⑦
should be 2mm lower than BASE
⑩ .
To adjust the cutters:
6. As shown below, the Steel Rod
① is 14mm. (loosen screw ② to
adjust the meshing pressure.
7. Loosen screw ⑥ to adjust the
Gap ④ between the Moving
Cutter ③ and the Fixed Cutter to
be 0.2 ~ 0.3mm.
8. If the Gap ④ is too big, it will
cause poor cutting and damage
the cutters.
P22
⑧
①
Slit 0.2-0.3mm when moving
⑥
knife close position
⑦
②
14mm
④
③ ⑤
⑩
⑨
2mm
Slit 0mm when
moving knife
close position