Table of Contents
Advertisement
Part 2: Start working with Auto
Mode:
1. Feed the band (refer to the
chapter of Feeding The Band)
2. Set the band length.
(1) Go the LENGTH ① on the
control panel for setting. The
effective setting range is
150~990 (mm). Value under
150 is taken as 150.
Note: the value is the folding
length only. The total length is
Lx2 mm.
(2) The LENGTH setting is only
a reference. The actual
length may be different due
to the material or quality of
the band. You can adjust
the setting based on the
difference.
3. Set the overlapping area.
(1) Go to the OVERLAP ② on the
control panel.
(2) Input the value for overlapping
setting. The default reference
should be "5＂. The bigger
the input value, the greater
the overlapping area.
4. Set the work piece counter.
(1) Go to the COUNTER ③ on
the control panel.
(2) Press COUNT RESET ④
first. Then input the value for
the work piece you want to
complete in this operation.
(3) When the work output
reaches the number you
input, the machine stops.
P12
L (Folding Length)
①
重疊量
LAPPING SIZE
②
重疊量
LAPPING SIZE
③
④
Advertisement
Table of Contents
