Setting The Butted Seam And Overlapping Area - Siruba ASP-EBJ100 Instruction Book

SETTING THE BUTTED SEAM AND OVERLAPPING AREA

Part 1: Initial Mechanical Setting (Preset done by maker. No need to apply step 1~5 unless a significant overlapping
difference, i.e. greater than 11mm).
For general operation setting, simply go to control panel setting (Part 2)
1. Loosen screw ① , move the left cylinder seat ② position to the desired position. (default value set to the 3rd red
mark ③ ).
2. Loosen screw ① , move the right cylinder seat ⑤ position to the desired position. (default value set to the 3rd
red mark ⑥ ).
3. Turn on the machine, and press START.
4. The 2 ends of the band ( ⑥ / ⑦ ) should meet at the center red line ⑨ of the feeding plate. If not, repeat step 1
and 2 to adjust accordingly.
5. All the mechanical parts are set and tested in our factory before delivery.
②
③
①
P8
⑤
⑥
④