Home - ETC Element User Manual

The following screenshots show a 7 color fixture. This display will change based on the type of
fixture being used.
Note:
The gray line shows the composite color of the fixture. If multiple fixtures are
selected, the gray line represents the first channel selected.
With the Gel Picker
That line represents the selected gel.
{Hold Color Point} allows you to adjust individual emitters and the other emitters will
automatically adjust to hold the color selected. This can only be used with fixtures that have
more than three color parameters.

Home

On Element, the {Home} softkey, located in the ML Controls, allows you to home a specific
parameter. Additionally, you may home all of a channel's non-intensity parameters or home
only a specific category (I, F, C, B). To home all parameters, use the {Home} button above {All
NPs}, and to home specific categories, use that category's {Home} button.
Homing a channel, category, parameter, or submaster will return it to the default value.
[1] {Home} [Enter] - homes all parameters for channel 1, except intensity.
•
[1] {Color Home} [Enter] - homes all color parameters for channel 1.
•
You can select a preset to provide home values for all non-intensity parameters (instead of
fixture library default values) when home commands are used. Store a preset with modified
home values for only the channel parameters you would like at a different value than default.
164
open and a gel selected, a dotted line will appear in the Spectrum display.
Eos Family v2.9.0 Operations Manual