Device - ETC Element User Manual

Highlight Rem Dim - This enables a remainder dim when in highlight mode, thereby
•
temporarily dimming any channel not participating in the High/Low. An intensity level or a
preset can be assigned in this field. Channels not in highlight or lowlight that are not
included in the preset are not affected.
Live RemDim Level - This allows you to set the level for all remainder dim commands in
•
live. The default is 0. An intensity level or a preset can be assigned in this field.
Default Times
In this section you may change the default times for sneak commands and the respective feature
response times based upon parameter category. The default for these is 5 seconds, except for
back time, which uses a default of 1 second. You can assign separate timing values to the
Release and Off functions.
You can assign [Cue] as a timing value for the {Go to Cue Time} and {Back Time} The syntax,
{Go to Cue Time} [Cue] [Enter] or {BackTime} [Cue] [Enter] will assign cue as the timing value.
When [Go To Cue] [n] [Enter] or [Back] is used, the fade will happen in the time set in the
destination cue.
You can assign a separate time value for [Timing Disable]. When a fader has been set to timing
disable mode, cues will use the time set in Setup. The default time is 0.
User Displays
This user setting button gives you access to the following display settings:
{Preserve Blind Cue} -This enables the desk to display the last selected cue in blind when
•
you return to blind. The default is disabled.
{Popup Magic Sheet} - assigns a magic sheet as a popup magic sheet.
•
{Popup Nav Lock} - enables or disables the zoom and scroll navigation for popup magic
•
sheets. This option is enabled by default.
See Popup Magic Sheet (on page 36)
information.

Device

This setup softkey accesses settings for the specific device. Changing these settings does not
impact other controllers on the network.
The following buttons are available in Device settings:
Config (below)
•
Outputs (on page 138)
•
Face Panel (on the facing page)
•
Displays (on page 144)
•
Trackball Settings (on page 145)
•
Brightness Settings (on page 145)
•
PDF Settings (on page 146)
•
Recall Device Settings (on page 146)
•
Config
Press {Config} to enter this category.
Two fields will be available to you: {Visible to Remotes} and {Device Name}.
142
and About Magic Sheets (on page 350) for more
Eos Family v2.9.0 Operations Manual