Customizing The Opn; Selecting The Usb Interface (Vcp Or Msd); Universal Menu Book Support - Opticon OPN2002 Applications Manual

Hide thumbs Also See for OPN2002:

Demo application manual (19 pages)

Manual (19 pages)

User manual (14 pages)

Table Of Contents

Table of Contents

Selecting the USB Interface (VCP or MSD)

This batch demo application supports three methods of retrieving your barcode data file from the OPN:

• USB Mass Storage Device (MSD)

• USB Virtual Com Port (USB-VCP) using NetO32 to retrieve the file

• CRD2000 multicradle using NetO32 to retrieve the file (OPN2002 only)

After loading this software on the OPN for the first time, the application will automatically be reset to USB-VCP default.

If you would like to use your OPN as a USB Mass Storage Device, scan the label below.

USB-MSD default

For more information on how to use your OPN as USB Mass Storage Device, see section

To switch back to USB-VCP default (i.e. to load software), scan the label below.

USB-VCP default

For more information on how to use your OPN as USB-VCP, see section

Independent of whether you configured your OPN2002 as Mass Storage Device (MSD) or as USB-VCP, it's always possible to transmit your barcodes using the

CRD2000 multicradle in combination with the NetO32-file transfer PC application.

Universal Menu Book Support *

The OPN supports the reading of various configuration options that can be found in our Universal Menu Book**. This makes it possible to customize your

application without having to actually change the source code of this demo software.

The OPN supports (most of the) menu options listed in the following chapters:

1. Defaults (see the supported default label listed above)

3.1 Enabling/disabling readable codes

3.2 Setting of fixed, minimum and maximum lengths of readable codes

3.3 Code specific options (most options are supported except 2D symbology options)

4.1 Case conversion

4.2 Set prefixes

4.3 Set suffixes

5.1 Read modes, add-on wait modes

5.1.1 Multiple read reset time

5.1.2 Quiet zone options (margins)

5.2 Read time options

5.4 Redundancy

5.5 Positive and negative barcodes

6.1 Buzzer settings

6.2 Good read LED options

7.1 Diagnostics

* This demo application does not implement any of the OPN2002's Bluetooth capabilities. A Bluetooth demo (RFG35317) for the OPN2002 is available on our

web site.

** The Universal Menu Book can be downloaded from the following link:

http://ftp.opticonusa.com/Downloads/Universal%20Menu%20Book.pdf