Rear View - Lightware MX32x32DVI-Pro User Manual

1.4.2 Rear view

CPU Card Reset
button switch contact closure
AC Power AC Input Cards Input Signal Detect
connector Fuse
CPU card
Reset button
DIP Switch
GPIO Contact closure Relay output for alarm signaling
DC voltage indicators
RS 232/422 connector 9 pole Dsub female connector. Can be ordered with
Ethernet port
CPU LIVE
AC Power
AC Fuse
Input cards
Input signal LED-s
Output cards
Page 12 / 79
DIP GPIO
1..4 LED-s
The main control unit of the device
Hardware reset button. Press to reset the whole frame.
Crosspoints and presets will not be resetted.
8 circuit DIP switch – not used in current version
LED indicators for internal DC power voltages
RS232 or RS422 control.
RJ 45 connector. Remote control port for connecting the
unit to Local Area Network.
Continuously blinking LED if the CPU works properly
Standard IEC power connector. The router works with
100 to 240 Volts, 50 or 60 Hz power sources.
Replace with F 3.15 A type only.
MX-DVID-IB: input board with 8 set of 24 pole single link
DVI–D
Connect DVI source devices to these connectors.
Indicates input signal presence (TMDS clock channel
active) on associated input connector: Green lighting
when signal is present.
MX-DVID-OB: output board with 8 set of 24 pole single
link DVI–D digital-only female receptacle connectors.
Connect
DC voltage RS232 Ethernet CPU Live
indicators port
Output Cards
1..4
digital-only female
DVI sink devices
port LED
Card activity
LED
receptacle connectors.
to these connectors.