Table of Contents
Advertisement
2.2.4 SAVE or LOAD PRESETS
The unit has 32 user programmable presets. Each preset stores a configuration
regarding all input connections for all outputs. All presets are stored in a non
volatile memory, the router keeps presets even in case of power down. Memory
numbers are assigned to source buttons 1 to 32 (MX32X32) or to 16 (MX16*16).
Saving a Preset in TAKE mode
1.
2.
3.
Info
Preset save action always stores the current configuration for all outputs
Loading a Preset in TAKE mode
1.
2.
3.
Info
Loading a preset always modifies all output states.
Saving a Preset in AUTOTAKE mode
1.
2.
Info
Preset save action always stores the current configuration for all outputs .
Loading a Preset in AUTOTAKE mode
1.
2.
Info
Loading a preset always modifies all output states.
2.2.5 VIEW current state
User can check the current switching status on the front panel using front panel
buttons. View mode is slightly different in TAKE or AUTOTAKE modes because of
different switching philosopy of the two modes.
Info
View mode does not mean, that the router has to be switched in different mode,
viewing and switching can be done after each other, without pressing any special
button.
Press and release SAVE PRESET button.
Press and release the desired source (memory address) button (source 1 to
32, or to 16)
Press and release TAKE button. Now the current configuration is stored in
selected memory.
Press and release LOAD PRESET button.
Press and release the desired source (memory address) button (source 1 to
32 or to 16)
Press and release TAKE button. Now the selected preset is loaded.
Press and release SAVE PRESET button.
Press and release the desired source (memory address) button (source 1 to
32 or to 16). Now the current configuration is stored in the selected memory.
Press and release LOAD PRESET button.
Press and release the desired source (memory address) button (source 1 to
32 or to 16). Now the selected preset is loaded.
MX32x32DVI-Pro
User's Manual
Page 19 / 79
Advertisement
Table of Contents
