Output Lock - Lightware MX32x32DVI-Pro User Manual

View current state in TAKE mode
If the router is in TAKE mode, user can verify both input and output connections. In
TAKE mode no accidental change can be done unless TAKE button is pressed.
Press and release a source button. Now the selected source button and all
destination buttons will light up which are currently connected to the selected
source. This informative display will remain for 5 seconds, then turns all buttons
unlit.
If all source and destination and TAKE buttons are unlit (the unit is in TAKE mode,
and no input was selected in last 5 seconds), press and release a destination
button to see its current state. Now the source button which is connected to the
selected destination will light up. If no source button is lighting, the selected
destination is in muted state. Pressing another destination button, there can be
seen the last pressed state of destination.
View current state in AUTOTAKE mode
In AUTOTAKE mode only states of destination can be viewed.
Press and release the required destination button. Now the source button which is
connected to the selected destination will light up. If no source button is lighting,
the selected destination is in muted state. Pressing another destination button,
there can be seen the last pressed current state of destination.

2.2.6 OUTPUT LOCK

Using Lightware routers there is a possibility to lock a destination. This feature
prevents an accidental switching to the locked destination in case of important
signal. Locking a destination means, that no input selection or muting can be done
on that particular destination.
Destinations can be indepentently locked or unlocked. Locking a destination does
not affect other destinations.
Output Lock in TAKE mode
1.
2.
3.
Unlock in TAKE mode
1.
2.
3.
Page 20 / 79
Press and release the required destination button. Now the selected
destination button and the currently configured source button light up (view
mode)
Press and release the Output Lock button. Now the Output Lock button
lights up in red colour.
Press and release TAKE button. The desired destination is locked now.
Press and release the required destination button which was previously
locked. Now the selected destination button and the currently configured
source button and the Output Lock button light up.
Press and release the Output Lock button (deselect). Now the Output Lock
button turns off, however the locking function has not been cancelled yet.
Press and release TAKE button. The desired destination is unlocked now.