Change Emulated Edid At One Or All Inputs - Lightware MX32x32DVI-Pro User Manual

7.4.1 Change emulated EDID at one or all inputs

All EDID are enumerated in the switch EDID list. If you want to modify the current
emulated resolution you can select one from this list. There is static EDID
emulation or dynamic EDID emulation.
-
-
Step 1.
Step 2.
Step 3.
If a monitor's EDID was selected to emulate ( DVI_OUT_1 to ..8) the emulated
Info
EDID will be changed all times on that input(s), when a new monitor was
connected. If the monitor was disconnected from output, the latest EDID remains, it
will not be deleted from the input. This feature helps especially rental technicians or
system integrators to keep the source continuously transmitting the signal, and
adopt the system for new incoming display devices.
Info Power ON/OFF cycle will not effect the emulated EDID or other settings.
Info EDID switch procedure causes a status change and hence it is reported back to
the CONTROL SOFTWARE within 2 seconds.
Page 64 / 79
Static EDID emulation means, when an EDID from memories 01..100 is
selected and emulated at input(s)
Dynamic EDID emulation occurs, when an attached monitor's EDID is
emulated at input(s), simply copying the data from the monitor. This EDID
changes automatically, if a new monitor is attached to the output.
Select the desired EDID from Switch EDID list ( from #1..100 through
DVI_OUT_1 ..to DVI_IN_32)
Select the input of the matrix switcher (or ALL inputs) where the
desired EDID will be emulated
Press TAKE button. Now the EDID has been changed on selected
output(s). After selecting a new EDID from the switch EDID list,
selecting a input (or the ALL item) and pressing the TAKE button the
MATRIX SWITCHER will modify that (or all) input(s) EDID.