Switching And Control Commands; Switch One Input To One Output; Switch One Input To All Outputs; View Connection On The Specified Output - Lightware MX32x32DVI-Pro User Manual

3.1 Switching and control commands

3.1.1 Switch one input to one output

Description: Switch input ii to output oo.
Example: Connect input 1 to output 5.

3.1.2 Switch one input to all outputs

Description: Switch input ii to all outputs.
Example: Switch input 1 to all outputs.

3.1.3 View connection on the specified output

Description: View connection on output oo.
Example: View connection on output 5.

3.1.4 View connection on all outputs

Description: Response length depends on the router's type (length = 16 for
MX16x16 frame, length = 32 for MX32x32) and is independent from the number of
installed outputs. The response above supposes a router having 32 outputs. The
16x16 frame responds only 16 outputs. Indexes show the actual output and the
number at the given index shows which input it is connected to. If value O5 equals
04 it means that output 5 is connected to input 4.
O1..O32 are two digit ascii characters. (01, 02, 04, etc.)

MX32x32 frames always respond 32 outputs while MX16x16 frames always respond 16 outputs.

Command
{VC}
(ALL●O1●O2●O3●O4●O5●O6●O7●O8●
Response
O9●O10●O11●O12●O13●O14●O15●O16●
O17●O18●O19●O20●O21●O22●O23●O24●
O25●O26●O27●O28●O29●O30●O31●O32●)CrLf
MX32x32DVI-Pro
User's Manual
Command {ii@oo}
Response (Ooo●Iii)CrLf
→
←
(O05 I01)CrLf
Command {ii@O}
Response (Iii●All)CrLf
→
{01@O}
←
(I01 All)CrLf
Command {?oo}
Response (Ooo●Iii)CrLf
→
{?05}
←
(O05 I01)CrLf
Page 23 / 79
{1@5}