Adjusting And Setting Depth Of Cut - Craftex CX series User Manual

ADJUSTING AND SETTING
DEPTH OF CUT
Depth of Cut
Depth of cut on a jointer refers to the amount
of material removed from the board face as
it passes over the cutterhead.
The depth of cut can be set by adjusting the
height of the infeed table in relation to the
cutterhead inserts at top dead centre and
the outfeed table.
Infeed Table Height Adjustment
In order to make adjustments to the infeed
table heights turn the infeed adjustment
knob to raise and lower infeed table.
Zero Adjustment Stop
The zero stop adjustment allows you to
consistently return the infeed table to the
point where it is even with the height of
the outfeed table.
Setting the Zero Stop
1. Make sure that the machin e i s
disconnected from the power supply.
2. Rest a straight edge on the surface
of the o u t f e e d t a b l e a n d u s e t h e
in feed table height adjustment knob
to raise or lower table until straight
edge is making even contact with
both the infeed and outfeed table when
achi eve d bot h t ables are a t e ve n
hei ght.
23