Rt (Gpi1 Configuration); I/O Diagnostic Commands; Tp (Board Temperature); Mac/Phy Commands - Digi XTend vB DigiMesh XTP9B-DPM-001 User Manual

Default
0x20 (3.2 seconds)

RT (GPI1 Configuration)

Sets or reads the behavior of the GPI1 pin (pin 10) of the device. You can configure the pin to enable RTS
flow control.
Parameter range
0 - 2
Parameter
0
1
2
Default
0 (disabled)

I/O diagnostic commands

The following AT commands are I/O diagnostic commands.

TP (Board Temperature)

The current module temperature in degrees Celsius in 8-bit two's compliment format. For example 0x1A =
26°C, and 0xF6 = -10°C.
Parameter range
(read-only) 0 - 0x7F
Default
N/A

MAC/PHY commands

The following AT commands are MAC/PHY commands.
XTend vB DigiMesh RF Module User Guide
Configuration
Disabled
N/A
RTS flow control
I/O diagnostic commands
47