Chapter 4
Tighten the 5/16" nuts to secure the muffler clamp and the bracket.
16.
Note:
Ensure that the sensor's rod is still extended approximately 1" before tightening.
Base End of Sensor Installed on Machine
FIGURE 7.
Secure the base end of the sensor to the base end of the steering cylinder using an M10 lock nut.
17.
Check for any interference between the sensor and the tractor.
18.
Note:
Make sure the sensor will not overextend or over-compress. Adjust the muffler clamps as needed.
28
Case IH Puma 115-160/New Holland Non-Delta Series T60x0 SmarTrax™ Installation Manual