Install The Valve Harness - Raven SmarTrax Installation Manual

Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.
Locate the ENABLE connector on the node harness (P/N 115-4001-109) and connect it to the foot switch
4.
cable connector.

Install the Valve Harness

Valve Harness Connected to Node Harness
FIGURE 4.
Connect the 12-pin connector of the valve harness (P/N 115-4001-096) into the mating 12-pin connector of
1.
the node harness (P/N 115-4001-109).
Valve Harness Routed Outside the Cab
FIGURE 5.
Route the valve harness out the cable access point in the left-rear corner of the cab and to the SmarTrax
2.
valve.
Manual No. 016-5034-012 Rev. A
Left Rear
Tire
Cab Component Installation
31