Fujitsu ScanSnap iX1500 Basic Operation Manual page 93

a The power LED turns off.
The ScanSnap is turned off and the ScanSnap Manager icon in the Dock changes from
to .
ATTENTION
l For iX1500/iX500/S1300i, close the ADF paper chute (cover) after putting the extension back.
l If moving the ScanSnap, first turn the power off and remove all cables.
l For iX1500/iX500/S1300i, the bottom part of the ScanSnap may become hot when the
ScanSnap is being used but this does not affect ScanSnap operation or cause any physical
harm. Be careful not to drop the ScanSnap when carrying it.
HINT
l For iX1500, the ScanSnap is turned on/off in conjunction with the computer's power if [Wi-Fi
off] is selected for [Wi-Fi connect mode] in the [Wi-Fi settings] screen on the touch panel and
if the ADF paper chute (cover) is open. If you keep the ScanSnap connected to the computer,
you do not have to worry about turning the power ON/OFF.
For details about how to select [Wi-Fi off] for [Wi-Fi connect mode], refer to
Wireless LAN Connection (iX1500)" (page
l For iX500/iX100, if the Wi-Fi switch is off, the power of the ScanSnap and the computer is
used to operate both devices. If you keep the ScanSnap connected to the computer, you do
not have to worry about turning the power ON/OFF.
l For S1300i/S1100i, the power of the ScanSnap is linked with the power of the computer to
which the ScanSnap is connected. If you keep the ScanSnap connected to the computer, you
do not have to worry about turning the power ON/OFF.
l For SV600 , when the computer is turned off, the ScanSnap is also turned off.
l For iX500/iX100/S1300i/S1100i, it may take 2 to 3 minutes until the light of the [Scan] button
goes out after the computer is turned off depending on some computers.
l When the ScanSnap is turned off, a notification window notifies you of the ScanSnap's
communication status.
To disable notifications of the ScanSnap's communication status, change the setting in the
following procedure:
1. Click the ScanSnap Manager icon
on the keyboard, and then select [Preferences] from the
(page 84).
a The [ScanSnap Manager - Preferences] window appears.
2. Clear the [Notify of the communication status] checkbox in the [Status Display] list.
157).
in the Dock while holding down the [control] key
"ScanSnap Manager Menu"
93
Turning the ScanSnap On or Off
"Turning Off the