Fujitsu ScanSnap iX1500 Basic Operation Manual page 220

Table of Contents

Advertisement

8.
Press the [Scan] button on the ScanSnap to start a scan.
a Both sides of the document are scanned and saved as one double-page spread image.
ATTENTION
l There may be a line or a gap appearing between the front and back side images. Also when you
scan a thick document in the Carrier Sheet, the scanned image on the left and the scanned image
on the right of a double-page spread image may skew towards each other from the top.
These symptoms may be improved when you place the document in the Carrier Sheet as follows:
-
Fold the document properly
-
Neatly align the edges of the document with the edges of the Carrier Sheet
-
Turn over the Carrier Sheet to the other (reverse) side
l If [Automatic detection] is specified for [Paper size] in the [Carrier Sheet Settings] window, an
optimal size will be selected automatically from the available standard sizes (A3, B4, or 11 × 17 in.)
in [Paper size]. Note that the size of the image may become smaller than the original document
depending on the document.
Example: When characters and illustrations are printed to fit in A4 size in the center of an A3
size document, the scanned image is output in B4 size.
To output the scanned image in its original size, specify the document size in [Paper size].
l Part of the scanned image around where the document is folded may appear missing. In that case,
place the document so that its edge is about 1 mm (0.04 in.) inside from the edge of the Carrier
Sheet.
HINT
Multiple Carrier Sheets can be loaded in the ADF paper chute (cover) and scanned.
220
Scanning Documents with iX500

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents