Fujitsu ScanSnap iX1500 Basic Operation Manual page 69

No. Name
6 [Scan] button (*1)
7 Wi-Fi indicator
8 Stacker
*1: When the ScanSnap has turned off automatically because of the automatic power off function,
either press the [Scan] button (this will not start scanning), or close the ADF paper chute (cover),
then open it again to turn the ScanSnap back on.
For details, refer to
Back
No. Name
9 Tape seal
10 Security cable slot
11 Power connector
12 USB connector
13 Ventilation port
14 WPS button
15 Wi-Fi switch
Description
Starts scanning. Can be pressed even when the stacker is closed.
Indicates the status of the ScanSnap as follows:
Blue (lit): Ready
Blue (flashing): Scanning
Orange (flashing): Error
Indicates the connection status between the ScanSnap and your
wireless access point as follows:
Blue (lit): Ready
Blue (flashing): Standby
Orange (lit): Not Connectable
Orange (flashing): Not Connectable (WPS error)
Open to use the stacker.
Stacks up the ejected documents.
"Automatic Power OFF (iX1500/iX500/iX100/SV600/S1300i)" (page
Description
Remove this tape seal after installing the software.
Used to connect an anti-theft security cable (commercially available).
Used to connect a power cable.
Used to connect a USB cable.
Holes for ventilating hot air from inside the ScanSnap.
Press this button to connect to a WPS compatible wireless access
point by using the push button method.
Turn this switch on to connect the ScanSnap to a wireless LAN.
9
10
11
12
13
14
15
69
Parts and Functions
96).