Fujitsu ScanSnap iX1500 Basic Operation Manual page 409

Feed Guide
3. Clean the following locations with a cloth moistened with Cleaner F1.
Glass (x 2)
l Glass (× 2, one on the top cover and one on the opposite side)
Gently wipe the dirt and dust off the surface of the glass sections.
l Idler roller (× 12, located on the top cover)
Gently wipe the dirt and dust off the rollers as you rotate them manually. Be careful not
to damage the surface of the rollers. Make sure that they are cleaned properly because
residue on the rollers will affect the feeding performance.
2.
Clean the feed rollers and eject rollers.
1. Connect the USB cable to the USB connector on the ScanSnap and the USB port on the
computer, and press the [Scan/Stop] button for three seconds with the top cover open.
ATTENTION
Connect the USB cable to the USB port on the computer only when cleaning the feed rollers
and eject rollers.
2. Clean the following locations with a cloth moistened with Cleaner F1.
Feed Roller (x 1)
l Feed roller (× 1, located on the scanner side)
Top Cover
Output Guide
Idler Roller (x 12)
Eject Roller (x 1)
409
Cleaning S1100i