Table of Contents
Advertisement
Node Harness Installed in Electrical Access Panel
FIGURE 5.
Reach behind the access panel cover and locate the 19-pin connector of the node harness.
10.
Insert the cable into the hole in the panel and secure it with the supplied lock washer and nut.
11.
Route the node harness cable connectors back into the cab.
12.
Reinstall the electrical panel cover.
13.
Node Mounting Locations
Node Mounting
FIGURE 6.
When choosing the location for the SmarTrax node, consider the following points:
•
Mount the SmarTrax node inside the machine's cab on a flat, level surface for proper performance and
cable connection.
•
One of the six numbered direction arrows on the node must be oriented in the direction of forward vehicle
travel, one arrow pointing straight up, and two of the arrows parallel to the ground.
Note:
Make a note of the number of the arrow that is oriented in the direction of forward vehicle travel.
This number will be needed during the SmarTrax calibration process.
•
The node mounting location must not create tripping hazards.
•
Mount the node in a location where it will not be kicked or jarred during normal equipment operation.
•
The location must allow cable routing to avoid crimping or damaging the cables or the node connections.
Manual No. 016-5034-014 Rev. A
Direction Arrows
Any two arrows must
be parallel with level
ground
Mounting Tabs
Cab Component Installation
11
Advertisement
Table of Contents
