Scanner Control Workstation Software Specifications
Feature
Operating system
Scanning software
Viewing software
System Requirements
You must use the workstation provided with the scanner and its calibrated monitor to scan. eSlide viewing also requires
using a workstation and two calibrated monitors provided by Leica Biosystems.
Environment Specifications
The Aperio AT2 DX is designed to be operated under the following environmental conditions: indoor use only, MAINS supply
voltage fluctuations of up to ± 10% of 100 - 120 V and 220 - 240 V, and transient overvoltages (category II of IEC 60364-4-
443) typically present on the MAINS supply. Also refer to the table below:
Feature
Transportation/storage temperature
Operating temperature
System heat dissipation
Power use
Transportation/storage humidity
Operating humidity
Maximum elevation
Routine setup and alignment may be required by a Leica Biosystems Technical Services representative after shipping.
Aperio AT2 DX User's Guide, Revision B © Leica Biosystems Imaging, Inc. 2020
Details
Windows 10 64-bit
Console / Controller
Aperio ImageScope DX
Details
-22 degrees Fahrenheit to 113 degrees Fahrenheit
-30 degrees Celsius to 45 degrees Celsius
65 – 81 degrees Fahrenheit
18 – 27 degrees Celsius
Typical BTU/hour: 1968
Typical watts/hour: 580
30% – 90%, non-condensed
30% – 90%, non-condensed, for a standard working pathology laboratory environment.
Up to 2000 Meters (6561.7 feet)
Appendix B: Specifications
57