Aperio At2 Dx Safety Instructions - Leica Aperio AT2 DX User Manual

C
This appendix contains important safety information for the Aperio AT2 DX scanner.
When using your scanner, always take basic safety precautions, including all of those listed below.
Read All Instructions – All safety and operating instructions must be read before operating the product.
Retain All Instructions – All safety and operating instructions must be retained for future reference.
1. Heed All Warnings – All warnings on the scanner and those listed in the operating instructions must be adhered
to.
2.
Follow All Instructions – All operating and scanner usage instructions must be followed.
3. Heat – The scanner must be situated away from any heat sources such as radiators, heat registers, stoves, or
other products that produce heat.
4.
Ventilation – Slots and openings in the scanner are provided for ventilation. They ensure reliable operation of
the product, keeping it from overheating. These openings must not be blocked nor covered during operation. Keep
air openings free of lint, hair, fluff, etc. This product should not be placed into a rack unless proper ventilation is
provided through following the manufacturer's recommended installation procedures.
The external light source should be placed in an area where air circulation is not impeded.
5. Biosafety Procedures – Please refer to your institution's biosafety policies and procedures regarding the proper
handling of tissue and other potentially hazardous materials in connection with the use of this device.
6.
Water and Moisture – Do not use the scanner near water—for example, near a water bath, wash bowl, kitchen
sink, or laundry tub; in a wet basement; or near an open pool of water or the like. If the scanner becomes wet,
unplug it before touching it.
7.
Attachments – Do not use any attachments not recommended by the product manufacturer as they may cause
hazards.
8. Power Sources – The scanner must be operated from the type of power source indicated on the marking label
and in the installation instructions. If you are not sure of the type of power supplied to your facility, consult your
local power company. Check that the voltage setting matches the electrical supply voltage.
9.
Grounding and Polarization – The scanner AC/DC adapter is equipped with a polarized AC plug with integral
safety ground pin. Do not defeat the safety ground in any manner.
10. Power Cord Protection – Power supply cords must be routed so that they are not likely to be walked on
nor pinched by items placed upon or against them. Pay particular attention to the cords at AC wall plugs and
convenience receptacles and at the point where the cord enters the AC/DC adapter.
58
Aperio AT2 DX Safety
Instructions
Aperio AT2 DX User's Guide, Revision B © Leica Biosystems Imaging, Inc. 2020