Introduction - Leica Aperio AT2 DX User Manual

Table of Contents

This Aperio AT2 DX scanner has been configured for and is part of the Aperio AT2 DX System, which includes:

The Aperio AT2 DX scanner, including a control/viewing workstation and calibrated monitors

Console scanning software

One or more Aperio AT2 DX Viewing Stations including two calibrated monitors for each station

Aperio ImageScope DX viewer

For a complete description of this system and the workflow for using it, refer to the Aperio AT2 DX System Overview.

The monitors provided with the Aperio AT2 DX System have been calibrated at the factory and may

require periodic re-calibration in the field by authorized Leica Biosystems technicians. Contact your

Leica Biosystems Technical Services representative for information. Do not attempt to change the

monitor display settings as doing so may interfere with the monitor calibration.

The Aperio AT2 DX System must only be used with the Aperio AT2 DX Viewing Stations provided as

part of the system.

The Aperio AT2 DX slide scanner has been manufactured to the highest quality standards. Refer to "Appendix C: Aperio

AT2 DX Safety Instructions" on page 58 for important information on safely operating your scanner—following these

safety guidelines will protect your unit and provide optimal operation.

Note that annual servicing is required to maintain scanner performance.

This equipment is intended to be used by trained, knowledgeable, licensed operators/technicians. Appropriate good

laboratory practices or other policies and procedures required by your institution must be followed in support of slide

preparation, processing, storage, and disposal.

Use this equipment only for this purpose and in the manner described in this guide.

Introduction

Table of Contents