Table of Contents
Advertisement
NOTE: The same unit name must be set for all the patient monitors and CARESCAPE Central
Stations (CSCS) that are connected to the same care unit in the MC Network. Bed name shall be
unique to each patient monitor in the same care unit.
NOTE: Unit and bed name selections are not available if network selection is S/5.
1.
Log in to Webmin.
2.
Select Configuration > Unit and Bed Name.
3.
In the Unit and Bed Name Configuration window, view or set the unit name and bed
name for the device.
NOTE: Use only capital letters A - Z, numbers, dash (-), asterisk (*) and space ( ). The unit name
may be up to seven characters long and bed name up to five characters long.
4.
Select Save.
The unit and bed name configuration takes effect immediately.
7.5 Configuring printers
You can configure the patient monitor to print to up to 12 laser printers connected on the IX
Network. Use the Webmin sub-modules to install or delete a printer and to print a test page.
NOTE: Ensure that you have the host name(s) or IP address(es) for all the connected IX printers
available. Configure the IX printers according to this information.
NOTE: Laser printers that are installed on central stations do not need to be configured using
Webmin. Refer to the user's manual for details on configuring the printer.
NOTE: Refer to the patient monitor's supplemental information manual for the list of supported
devices.
7.5.1 Installing a printer
1.
Log in to Webmin.
2.
Select Configuration > Printers.
3.
In the Sub-Modules for Printers menu, select Install Printer.
4.
Below Printer Configuration Information in the Install Printer window, provide the
following information:
a.
b.
c.
d.
5.
Select Save.
6.
From the patient monitor, select Monitor Setup > Printing.
7.
Select the Devices > Setup.
8.
In the Printout menu, select what to print out (for example, Waveforms, Alarm
Waveforms, Numeric Trends, Reports).
9.
Below Location, select the radio button next to Network.
10. From the drop-down list next to Network Device, select the desired printer.
The change will take effect immediately.
Select either the Hostname or IP Address radio button, as applicable.
In the Hostname or IP Address field, enter the printer Hostname or IP Address.
In the Printer Name field, enter the Printer Name.
Select Yes from the drop-down list next to Test Page.
Configuration
73
2106778-001
Advertisement
Table of Contents
Troubleshooting
