CARESCAPE Monitor B850
1.
With the module properly oriented, align the module insertion guide slot with the insertion
guide.
2.
Push the module into the frame until it clicks.
3.
To remove a parameter module, grasp it firmly, press the release lever on bottom of
module, and pull out of the guides.
6.4.5 Connecting a PDM module to an F5 Frame
NOTE: When the PDM is used without a battery, it is necessary to allow additional time to power
up. Do not interrupt the startup sequence by unplugging the PDM.
1.
Align the PDM with the insertion guides on the outside of the frame. Push the module into
the frame until it stops.
6.4.6 Installing a PDM module to a mounting solution
WARNING
PHYSICAL INJURY- Take care when mounting devices to an IV pole. If a
device is mounted too high the IV pole may become unbalanced and tip
over.
62
2106778-001