Ra-2000 Remote Annunciator Installation; 1: Mounting The Ra-2000; Flush Mounting - Honeywell Farenhyt Series Installation And Operation Manual
Addressable fire alarm control system emergency communication system
Hide thumbs
Also See for Farenhyt Series:
- Manual (176 pages) ,
- Installation and maintenance instructions (4 pages) ,
- Installation instruction (2 pages)
Table of Contents
Advertisement
4.7 RA-2000 Remote Annunciator Installation
The optional Model RA-2000 Remote Annunciator, (see Figure 4.20). The RA-2000 can be surface or flush mounted. It is available in
gray color as RA-2000GRAY as shown.
RA-2000 installation involves the following steps:
1.
Make sure power is off at the panel.
2.
Mount the RA-2000 in the desired location (see Section 4.7.1).
3.
Connect the RA-2000 to the panel (see Section 4.7.2).
4.
Use the DIP switches on the back of the RA-2000 to assign an SBUS ID# to the RA-2000.
5.
The RA-2000 module must be added to the system through programming. JumpStart
Section 8.1.3). You can also add it manually (see Section 9.2.2). Select a name, if desired (See "Naming Modules" on page 110.).
4.7.1 Mounting the RA-2000
This section of the manual describes mounting the remote annunciator. The annunciator can be flush or surface mounted.
Flush Mounting
This section of the manual describes flush mounting.
37
Figure 4.20 Model RA-2000GRAY Remote Annunciator, Front View
IFP-300 / IFP-300ECS Manual P/N LS10145-001SK-E:B 12/18/2017
®
will add the module automatically (see
Advertisement
Table of Contents
Troubleshooting
