Installing Wheels - MacDon Draper D65 Installation Instructions Manual

3.10 Installing Wheels

To install the wheels, follow these steps:
1. Attach the four wheels to hubs with bolts provided in hubs.
2. Torque wheel bolts to 110–120 Nm (80–90·lbf·ft). Refer to
bolt tightening sequence illustration at right.
3. Check tire inflation pressure. Inflate to 448 kPa (65 psi).
IMPORTANT:
Do not exceed maximum pressure specified on tire
sidewall.
NOTE:
Height adjustment procedures for stabilizer wheels in field
mode are provided in your header operator's manual.
169784
INSTALLATION INSTRUCTIONS
Figure 3.58: Wheel Bolt Tightening Sequence
41
1
3
6
5
4
2
Revision H