Checking Axle Hub Pivot - MacDon Draper D65 Installation Instructions Manual

3.8 Checking Axle Hub Pivot

Perform the following check to ensure that the wheel hub pivot is snug while in the transport position.
1. Check that hub pivot (A) is in transport position and ensure
that L-pin (B) has locked the hub.
2. Check hub pivot (A) for looseness.
3. If hub pivot (A) is snug, check that L-pin (B) can move freely
out of and into lock position (down).
4. If L-pin (B) is jammed, loosen jam nut (C) and turn adjuster
bolt (D) until L-pin (B) can move. When properly adjusted,
hub pivot (A) should be snug and L-pin (B) should move
freely.
5. If hub pivot (A) is loose when L-pin (B) is engaged, turn
adjuster bolt (D) until hub pivot (A) is snug. When properly
adjusted, L-pin (B) should move freely.
6. Tighten jam nut (C).
169784
INSTALLATION INSTRUCTIONS
Figure 3.52: Swing Axle
Figure 3.53: Fixed Axle
38
B
D
A
C
B
D
C
A
Revision H