Installing Light Wiring Harness - MacDon Draper D65 Installation Instructions Manual

3. Install light assembly (A) inside reel right support arm with
two 1/2 NC x 1-1/2 in. hex bolts (B) (MD #18723) and
smooth face lock nuts (MD #50186). Tighten bolts.

3.12.3 Installing Light Wiring Harness

To install the light wiring harness, follow these steps:
1. Retrieve wiring harness (MD #193080) from transport kit.
2. Remove bolt (A) and remove inside clamp (B) at aft end of
reel arm.
3. Feed the long portion with the square connector (A) into
reel arm aft end. Hoses (B) inside reel arm may need to be
moved aside. The locking tab on connector (A) should be
situated at the bottom when feeding it into the reel arm.
169784
INSTALLATION INSTRUCTIONS
Figure 3.67: Light Installed on Reel Arm
Figure 3.68: End of Reel Arm
Figure 3.69: End of Reel Arm
45
A
B
A
B
B
A
Revision H