Tow-Bar Brackets; Installing Bracket On Left Endsheet; Installing Bracket On Right Endsheet - 9.1 Meter (30 Foot) D65 Headers - MacDon Draper D65 Installation Instructions Manual

3.16 Tow-Bar Brackets

The tow-bar is stored on the header just behind the backtube. It is secured to each endsheet with a bracket and to the
backtube with two cradles.
The 9.1 m (30 ft.) D65 Draper Header uses a different bracket on the right endsheet from other models. Both bracket types
are included in the kit.

3.16.1 Installing Bracket on Left Endsheet

Install the tow-bar bracket on the left endsheet as follows:
1. At the left endsheet inboard side, install bracket (A)
(MD #193188) on channel with two 3/8 NC x 3/4 in.
carriage bolts (B) and flanged smooth-faced nuts.
3.16.2 Installing Bracket on Right Endsheet – 9.1 Meter (30 Foot) D65 Headers
This procedure only applies to 9.1 m (30 ft.) D65 Draper Headers. For instructions on installing the tow-bar bracket on the
right endsheet of any other model, refer to
Foot) D65 Headers, page 58.
1. At the right endsheet inboard side, remove the bolt and
harness clip at location (A) that attaches the wiring harness
to the endsheet.
NOTE:
An overlay for the pilot hole drilling template provided in
the kit is shown in the illustration at right.
169784
INSTALLATION INSTRUCTIONS
Figure 3.90: Left Endsheet
A - Bracket
C - 55 mm (2 3/16 in.)
3.16.3 Installing Bracket on Right Endsheet – Headers Except the 9.1 Meter (30
Figure 3.91: Right Endsheet
56
C
A
B
B - Carriage Bolts
A
Revision H