Connecting Harness On Non-European Headers (With Module) - MacDon Draper D65 Installation Instructions Manual

3.12.5 Connecting Harness on Non-European Headers (with Module)

This topic is for D65 and FD75 headers sold outside of Europe. For instructions on connecting the lighting harness on
European headers, refer to
1. Remove cap from connector (A) on existing harness and
attach connector to light module connector (B).
2. Connect lighting harness flat connector (C) to light module
connector (D).
3. Connect lighting harness square connector (E) to light
square connector (F).
4. Bundle harnesses into light fixture and secure with cable
tie (A).
5. Reinstall lighting cover (B) and tighten screws (C).
169784
INSTALLATION INSTRUCTIONS
3.12.6 Connecting Harness on European Headers (without Module), page
A
Figure 3.78: Endsheet
B
Figure 3.79: Endsheet
49
50.
E
F
B
D
C
C
A
C
Revision H