3.6 Installing Rear Fixed Axle
1. Remove skid shoe if needed. Refer to the header operator's
manual for procedure.
2. Position a 2 x 4 wooden block (A) or equivalent between
the right leg and draper to allow installation of the support
assembly.
3. Remove bolt (A), washers, and nut from pivot casting (B).
4. Remove bolt and nut (C) from pivot casting (B).
5. Check that spacer (A) is installed in axle.
169784
INSTALLATION INSTRUCTIONS
Figure 3.37: Wooden Block between Right Leg
and Draper
Figure 3.38: Pivot Casting
Figure 3.39: Fixed Axle Assembly
32
A
C
A
B
A
Revision H