Installing Rear Swing Axle - MacDon Draper D65 Installation Instructions Manual

3.7 Installing Rear Swing Axle

1. Remove 5/8 NC x 4 1/2 in. bolt (A) from axle support
swivel (B). Ensure spacer (C) remains in place. Make note of
hardware orientation for replacement in the next step.
IMPORTANT:
To prevent equipment failure, tighten bolts to the specified
torque values.
2. Position swing axle (C) on axle support swivel (B), and
attach with 5/8 NC x 4 1/2 in. bolt (A) and nut. Torque to
217 Nm (160·lbf·ft).
3. Set the swing axle perpendicular or slightly forward of
perpendicular to cutterbar.
4. Raise axle support.
169784
INSTALLATION INSTRUCTIONS
A
Figure 3.48: Rear Swing Axle
Figure 3.49: Rear Swing Axle
Figure 3.50: Rear Swing Axle
A - 88–90°
36
C
A
B
B
C
A
Revision H