Installing Splice - MacDon Draper D65 Installation Instructions Manual

4. Route harness (A) to forward end of arm and make
connection (B) at light.
5. Secure harness (A) to inside of reel arm with two clamps (C)
(MD #135233), 3/8 NC x 3/4 in. carriage bolts (MD #21863),
and smooth face lock nuts (MD #30228).
6. Place harness (A) and hoses in clamp (B) at aft end of arm
and secure inside arm with existing hex bolt (C) and nut.

3.12.4 Installing Splice

This modification is applicable to transport lights without a module that were manufactured prior to model year 2013.
The lighting harness at the endsheet transport light needs to be modified to include a splice at the 6-pin flat connector. For
more information, refer to
1. Locate the 6-pin flat connector (A) at the end of the header
portion of the electrical harness (B).
169784
INSTALLATION INSTRUCTIONS
Electrical Schematics – European (without Module, with Splice), page
B
C
Figure 3.70: Reel Arm – Bottom View
Figure 3.71: End of Reel Arm
Figure 3.72: Connector
46
A
C
B
A
51.
B
A
Revision H