Installing Reel Arm Light - MacDon Draper D65 Installation Instructions Manual

7. Reinstall bracket (A) on lighting cover (B) with existing
hardware (C).
8. Position light assembly (A) on endsheet, picking up existing
holes, and install three 3/8 NC x 3/4 in. carriage bolts (B)
(MD #21472) and flange nuts (MD #30228).
9. Do NOT reinstall lighting cover at this time.

3.12.2 Installing Reel Arm Light

To install the reel arm light, follow these steps:
1. Retrieve right rear light assembly from transport kit.
2. Remove the two outboard existing bolts (A) that attach
fore-aft cylinder support to reel arm.
169784
INSTALLATION INSTRUCTIONS
Figure 3.64: Light Cover
A
Figure 3.65: Light Installed on Endsheet with
Endshield Removed
Figure 3.66: Reel Arm
44
B
A
B
A
C
1011724
Revision H