Rear Suspension And Right Side Tow-Bar Cradle; Installing Rear Suspension And Right Tow-Bar Cradle On A 9.1 Meter (30 Foot) D65 Windrower Header - MacDon Draper D65 Installation Instructions Manual

3.5 Rear Suspension and Right Side Tow-Bar Cradle

The procedure for installing the rear suspension and the right side tow-bar cradle varies depending on the header type and
width. See the appropriate procedure below:
•
3.5.1 Installing Rear Suspension and Right Tow-Bar Cradle on a 9.1 Meter (30 Foot) D65 Windrower Header, page 27
•
3.5.2 Installing Rear Suspension and Right Side Tow-Bar Cradle on All Headers Except the 9.1 Meter (30 Foot) D65
Windrower Header, page 29
3.5.1 Installing Rear Suspension and Right Tow-Bar Cradle on a 9.1 Meter (30 Foot)
D65 Windrower Header
To install the rear suspension and right tow-bar cradle, follow these steps:
1. Loosely install four 3/8 NC x 1 in. carriage bolts (A)
(MD #100456) at the base of the vertical leg. Install bolts
from inside leg.
2. Lift axle (A) and channel/spring subassembly (B), and
position lower end of subassembly (B) into leg.
3. Position lower end of subassembly (B) on bolts (C).
4. Slide subassembly (B) into leg.
5. Fasten subassembly to leg at location (C) with four flange
nuts (MD #30228).
6. Attach top of subassembly (B) to leg with two
3/8 NC x 3/4 in. carriage bolts (D) and smooth face lock
nuts in right of leg, and two 3/8 NC x 1 in. carriage bolts (E)
(MD #100456) and smooth face lock nuts (MD #30228) in
left of leg. Install bolts from inside leg. Tighten all hardware
except bolts (E).
169784
INSTALLATION INSTRUCTIONS
Figure 3.26: Right Header Leg
Figure 3.27: Right Header Leg
27
A
E
D
B
C
C
A
Revision H