Fast Idle Lever (R1 Type)/Fast Idle Button (R2, R3 Types) - TOHATSU BFT 200D Owner's Manual

Fast Idle Lever (R1 type)/Fast Idle
Button (R2, R3 types)
The fast idle lever/fast idle button is
only needed for starting carbureted
outboard models. The BFT200D,
BFT225D and BFT250D models use
programmed fuel injection so, this
lever will not be needed for starting.
After the engine starts and if the
outside temperature is below 5°C
(41°F), the fast idle lever/fast idle
button can be used to accelerate
engine warm up.
<Fast Idle Lever>
(R1 type)
REMOTE
NEUTRAL
CONTROL
LEVER
MAXIMUM
FAST IDLE
FAST IDLE LEVER
The fast idle lever will not move
unless the remote control lever is in
the NEUTRAL position. Conversely,
the remote control lever will not
move unless the fast idle lever is in
the lowest position.
Lower the fast idle lever to the lowest
position to decrease the fast idle.
https://www.boat-manuals.com/
CONTROLS AND FEATURES
<Fast Idle Button>
(R2 type)
FORWARD
LOWEST
POSITION
REMOTE
CONTROL
LEVER
Pushing the fast idle button, turn the
remote control lever forward. Keep
turning the lever forward. The throttle
opens and the engine speed increases
after the lever passed the shift point.
Note that the gearshift mechanism
does not function when the fast idle
button is pushed once and then
released after the remote control lever
is moved.
The control lever does not operate
unless the neutral release lever is
pulled.
NEUTRAL
REVERSE
NEUTRAL
Pull up
RELEASE
LEVER
FAST IDLE
BUTTON
Push
31