Table of Contents
Advertisement
IGNITION COIL
WIRE CONNECTOR
3. Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
4. Use a 10 mm wrench to remove the
bolt holding the ignition coil.
Remove the ignition coil by pulling
it up slightly. Take care not give an
impact or drop the ignition coil.
Replace the ignition coil if drop it.
SPARK PLUG WRENCH
BOLT
5. Use the spark plug wrench and 19
mm eye wrench to remove the
spark plugs.
https://www.boat-manuals.com/
New plug
19 mm EYE
WRENCH
6. Inspect the spark plugs.
(1) If the electrodes are heavily
corroded or carbon-soiled, clean
with a wire brush.
(2) Replace a spark plug if the
central electrode is worn.
The spark plug can wear out in
different ways.
If the sealing washer shows
signs of wear, or if the
insulators are cracked or
chipped, replace the spark plugs.
MAINTENANCE
Plug needing
replacement
119
Advertisement
Table of Contents
