(R1 Type) - TOHATSU BFT 200D Owner's Manual

Hide thumbs Also See for BFT 200D:
Table of Contents

Advertisement

STARTING THE ENGINE
6. Check to see if the oil pressure
indicator turns ON.
If it does not turn on, stop the engine
and perform the following
inspections.
1) Check the oil level (see page 58).
2) If the oil level is normal and the oil
pressure indicator does not turn
ON, consult with an authorized
TOHATSU outboard motor dealer.
7. Warm up the engine as follows:
Above 5°C (41°F) – run the engine
for 2 or 3 minutes.
Below 5°C (41°F) – run the engine
for at least 5 minutes at 2,000 min
(rpm).
Failure to completely warm up the
engine will result in poor engine
performance.
70
If the engine is not properly
warmed-up before raising the
engine speed, the warning buzzer
and overheat indicator may
activate and the engine speed will
be automatically reduced.
Before leaving the dock, check the
operation of the emergency stop
switch.
-1
https://www.boat-manuals.com/

(R1 type)

EMERGENCY STOP SWITCH
EMERGENCY STOP
SWITCH LANYARD
EMERGENCY STOP
SWITCH CLIP
WARNING
Exhaust contains poisonous
carbon monoxide which can
cause unconsciousness and may
lead to death. Never run the
outboard motor in a boat house or
other confined area.
To prevent damage to the outboard
from overheating, never run the
engine with the propeller out of
water.
STOP

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bft 225dBft 250d

Table of Contents