TOHATSU BFT 200D Owner's Manual page 74

Hide thumbs Also See for BFT 200D:
Table of Contents

Advertisement

STARTING THE ENGINE
ON START
OFF
ENGINE SWITCH KEY
3. Turn the engine switch key to the
START position and hold it there
until the engine starts.
When the engine starts, release the
key, allowing it to return to the ON
position.
72
• The starter motor consumes a
large amount of current. Do not
therefore run it continuously for
more than 5 seconds at a time. If
the engine does not start within 5
seconds, wait at least 10 seconds
before running the starter motor
again.
• Do not turn the engine switch key
to the START position while the
engine is running.
https://www.boat-manuals.com/
COOLING WATER CHECK HOLE
COOLING WATER INTAKE PORT
(each side)
4. After starting, check whether the
cooling water is flowing out of the
cooling water check hole. Amount
of water flowing out of the check
hole might vary due to the
thermostat operation, but this is
normal.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bft 225dBft 250d

Table of Contents