Key Operations In Function Selecting Mode; Key Operations In Setting Mode - KYOWA WGA-680A Series Instruction Manual

4-1-3. Key operations in FUNCTION SELECTING mode

To go to the FUNCTION SELECTING mode, press the FUNCTION key for 2 seconds in the
MEASURING mode. The "F-01" is displayed on the indicator and you are able to select functions.
To select the functions from "F-01" to "F-26" on the FUNCTION SELECTING mode, press the
or SHIFT +
To determine the function, press the SET key. The mode goes to the SETTING mode.
To back to the MEASURING mode, press the CANCEL key on the FUNCTION SELECTING mode.

4-1-4. Key operations in SETTING mode

Press the SET key after selecting the function on the FUNCTION SELECTING mode, the mode goes to
the function's SETTING mode.
To set numerical values.
Move digits
Change numerical values
Register pre-set values
When numeric values are not required to set, "...." is displayed. Press the SET key in this status, the
function is executed.
To back to the FUNCTION SELECTING mode, press the CANCEL key on the SETTING mode.
To set numerical values.
(1)Setting available digit flickers.
(2)To move the target digit to the right, press the
The flickering digit moves the leftmost digit next to the rightmost digit.
The leftmost digit (5th digit)
Other digit (1st to 4th digit)
(4)To set the decimal point, when the function is in the calibration function.
key.
: Press the
: Press the
: Press the SET key.
The changed value is determined and stored (registered) in the
internal memory.
key, key + SHIFT key.
key.
19
IM-A-1048H
key