KYOWA WGA-680A Series Instruction Manual page 57

(16) Comparator function
(17) Hold function
(18) Display
(19) Analog output
(20) Control input
(21) Control output
(22) Level test signal
The number of points: 4
Pattern: Registers 4 groups of pattern files (comparative values) and
enables switching through setting of functions
Type: extra high [HH], high [HI], OK, low [LO], extra low [LL]
Setting range: ±99999
Hysteresis width: 0 to 99999
Comparison mode: normal, at hold
High/Low assignment:
Enables assigning high or low to each comparator
Digital peak/bottom hold (without analog peak/bottom hold)
Type: Arbitrary point hold, peak hold, bottom hold,
peak to peak hold, interval definition peak hold,
time specification peak hold, interval definition bottom hold,
time specification bottom hold,
interval definition peak to peak hold,
time specification peak to peak hold
Delay time: 0.00 to 9.99 s.
Detect time: 0.01 to 9.99 s.
Display range: ±99999
Display: 7 segment LED, Character Height 14 mm,
Color: red/green/orange
Update Speed: 0.12, 0.24, 0.49, 0.98, 1.95, 3.90, 7.80, and 15.6 times/s
Display Mode: normal, at hold
Determinator: 5 points (HH, HI, OK, LO, LL)
Status display: 2 points (HOLD, LOCK)
Voltage Output: ±10 V (Load resistance 2 k
Possible to scaling arbitrarily
Current Output: 4 to 20 mA (Load resistance 500
Corresponds to voltage output of 0 to 10 V.
Conversion Speed: 4000 times/s
Non-linearity: Within ±0.1 %FS
Setting contents: Display value of zero, Display value of full scale
The number of points:
Type:
Signal Format:
The number of points: 5
Type: HH, HI, OK, LO, and LL
Output Format: Open collector (Capacity: 30 VDC, 20 mA max)
Display of arbitrary values possible
Display additional function: Disabled, Enabled
Setting range: ±99999
Level test: ON, OFF
56
3
Zero order, hold order, and reset order
Non-voltage contact signal, or open collector
(Capacity: 12 VDC, 5 mA or more)
IM-A-1048H
)
or less)