Table of Contents
Advertisement
Resetting the StackMaster™TR 16-Port
3-12
NOTE: The StackMaster™TR 16-Port can be reset in any of the following
ways:.
•
Disconnect power cord to StackMaster™TR 16-Port unit with installed
SNMP management board, then reconnect the power cord.
•
Press the reset button on the StackMaster™TR 16-Port unit with
installed SNMP management board
•
At the attached terminal or terminal emulation, type and enter:
ANY MENU>
ANY MENU>
At power on or reset, the Status LEDs cycle through diagnostic test patterns
as internal StackMaster™TR 16-Port software tests: Flash, serial port,
dynamic RAM, static RAM, dual port memory, and each of the Ethernet
ports.
After the diagnostic test patterns, for twenty seconds, the Status LEDs
display a pattern in which four LEDs remain illuminated while four LEDs
flash continuously. This pattern indicates that the StackMaster™TR 16-Port
software is waiting for an optional user interrupt.
restart
quit
StackMasterTR
Advertisement
Table of Contents
Related Manuals for Transition Networks STACKMASTER TR SMHB-TR-16
Related Products for Transition Networks STACKMASTER TR SMHB-TR-16
- Transition Networks SMHB-E-TX-12
- Transition Networks StackMaster SMHB-E-FL-12
- Transition Networks StackMaster SMHB-E-FL-6
- Transition Networks StackMaster SMHB-E-TBT-24
- Transition Networks StackMaster SMHB-E-TBT-16
- Transition Networks SMME-E
- Transition Networks SM8T2DPA
- Transition Networks SM24TAT4GPA
Need help?
Do you have a question about the STACKMASTER TR SMHB-TR-16 and is the answer not in the manual?