Diagnostic Trouble Codes (Dtc); Accessing Dtcs Through Engine Can - Husqvarna Wacker Neuson CRT60-74LX Operator's Manual

CRT60-74LX
9

Diagnostic Trouble Codes (DTC)

9.1

Accessing DTCs through engine CAN

Overview The engine Controller Area Network (CAN) display is connected to the engine and
can display information such as:
■ Engine run time
■ Engine RPM
■ Engine error codes or DTCs
■ Other engine parameters
Correcting Perform the procedure below to correct an error code.
error codes
1. Identify the error code.
2. Verify that system voltage is within the proper 12 volt system range
(11–14 volts).
3. Check for loose or disconnected electrical connections in the steering circuit.
This includes both joystick connectors, both controller connectors, six cartridge
valve connectors, and ground.
4. If system voltage is within range, and all electrical connections are tight, contact
an authorized Wacker Neuson service center to correct the error.
wc_tx004003gb_FM10.fm
Diagnostic Trouble Codes (DTC)
93