Husqvarna Wacker Neuson CRT60-74LX Operator's Manual page 71

CRT60-74LX
Continued from the previous page.
■ The hydraulic oil should fill the overflow bottle to the level indicator (c) on the
side of the bottle when the machine is at room temperature.
■ Over-filling the bottle could cause spilling as the hydraulic oil warms and
expands.
Add fresh hydraulic oil if necessary.
Note: An empty overflow bottle may indicate the main reservoir is not filled.
Draining used Perform the procedure below to drain the hydraulic oil.
hydraulic oil
1. Park the machine on a flat, level surface. Use the wheel kit to raise the machine
off the level surface.
2. Stop the engine.
3. Remove the cap (d) from the overflow bottle.
4. The hydraulic oil drain port (e) is located at the front of the machine beneath the
foot area. Place a suitable container beneath the drain port.
5. Disconnect the hydraulic hose (f) and drain the hydraulic oil into the container.
This procedure continues on the next page.
wc_tx004561gb.fm
5100040086
c
wc_gr014686
d
71
Maintenance
e
f
wc_gr012372